Reading for specific information. Read the text, choose a right word

2. Read the text. Find and translate all the sentences containing the following word combinations:

• heating and ventilation

• air-conditioning

• a hot-water system

• central heating

• cooling of the steam

• panel heating

Besides masonry, a brick work, any engineer must know about heating and ventilation. They are two branches of engineering which are very closely connected. Both they are treated as a dual subject. Heating is to prevent too rapid loss of heat from the body. The rate of heat lost from the body is controlled. Some old concepts of heating have been gradually changed since engineers obtained more precise knowledge about how the body loses heat. Insufficient attention was paid formerly to loss by radiation, which is the transmission of energy in the form of waves from a body to surrounding bodies at a temperature. The human being also loses heat by conduction (through his clothes) and convection, the latter by air currents not only past his skin or outside clothing surface but also by evaporation of moisture from his skin (respiration).

The determination of the capacity or size of the various components of the heating system is based on the fundamental concept that heat supplied to a space equals heat lost from the space. The most widely used system of heating is the central heating.

There are two most common systems of heating: hot water and steam. There the fuel is burned in one place, from which steam, hot water or warm air is distributed to adjacent and remote spaces to be heated. Both systems are widely used nowadays. A hot-water system consists of the boilers and a system of pipes connected to radiators suitably located in the rooms. The steel or copper pipes give hot water to radiators or convectors which give up their heat to the rooms. Then cooled water is returned to the boiler for reheating. As for steam systems, steam is usually generated. The steam is led to the radiators through or by means of steel or copper pipes. The steam gives up its heat to the radiators and the radiators to the room. After this cooling of the steam condenses to water. The condensate is returned to the boiler by gravity or by a pump. The air valve on each radiator is necessary for air to escape. Otherwise it would prevent steam from entering the radiator.

Recent efforts have resulted to completely conceal heating equipment in an arrangement. Hot water, steam, air, or electricity are circulated through distribution units embedded in the building construction. Panel heating is a method of introducing heat to rooms in which emitting surfaces are usually completely concealed in the floor, walls or ceiling. The heat is disseminated from such panels partly by radiation and partly by convection. Ceiling panels release the largest proportion of heat by radiation and floor panels release the smallest one. The proportion of heat disseminated by radiation and convection is also dependent to some extent upon panel-surface temperatures. Other factors must be considered by an engineer. They are a type of occupancy, furniture or equipment location, large glass areas, heat-storing capacity of building construction, room height, and possible change of wall partitions, climate, exposure, cost. Sometimes fuel is used for heating. They include coal, oil, manufactured and natural gas, wood. Nowadays gas fuel is being used on an increasing level.